Mold Remediation · San Antonio · TDLRMold Gone. Done By The Book.
Both Texas mold licenses, sealed containment and clearance-ready documentation.

Two State Licenses, One Crew
We hold both TDLR credentials required to remediate mold in Texas — and we were among the first in the state to earn a mold remediation license when licensing began in 2004.
- TDLR Mold Remediation Company #RCO0176
- TDLR Mold Remediation Contractor #MRC0212
- Licensed, bonded and insured
- Protocols written for third-party clearance testing

2
TDLR licenses held — company and contractor.
Contain. Remove. Verify.
Sealed containment, negative air and HEPA filtration keep spores out of clean rooms.
- Sealed containment and negative pressure
- HEPA air scrubbing throughout
- Antimicrobial treatment of framing
- Post-remediation documentation package

What to Expect
- 1
Call, Any Hour
We answer 24/7/365. Tell us what you see and when the leak or odor began. Photos help.
- 2
Inspection and Source
We find the moisture source and map the affected material before a scope is set. You get that scope in writing.
- 3
Protocol When Texas Requires One
On a regulated project, an independent licensed mold assessment consultant writes the protocol and performs clearance. We do not grade our own work.
- 4
Containment and Removal
The work area is sealed, put under negative pressure and filtered through HEPA. Materials that cannot be cleaned come out. What remains is cleaned and treated.
- 5
Drying and Documentation
Once the water source is stopped, the structure is dried by moisture readings rather than touch. The work is documented with photos and records your insurer or a buyer's inspector can use.
Mold Remediation Questions
Are you licensed for mold remediation in Texas?
Yes. We hold TDLR Mold Remediation Company license #RCO0176 and TDLR Mold Remediation Contractor license #MRC0212, and we were among the first licensed when Texas began licensing mold remediation in 2004. Our technicians are IICRC certified.
Can I just clean mold with bleach?
Bleach can lighten a stain on a hard surface, but on drywall, wood and insulation the visible surface is only part of the material. Spraying leaves the source in place and adds moisture. For a small spot on a hard, nonporous bathroom surface, routine cleaning and better moisture control may be enough. Soft drywall, insulation or wood that stayed wet may need removal instead.
Why do you build containment for a small patch?
Removal is the dusty part of the job. Cutting mold-damaged drywall releases dust and fragments that foot traffic and air movement can carry into other rooms and the HVAC return. Sealed containment with negative air and HEPA filtration keeps that debris in the work zone.
Who writes the protocol and performs clearance?
Texas separates assessment from remediation on projects above the state threshold. An independent licensed mold assessment consultant establishes the protocol and performs clearance, so the remediator does not write its own passing grade. Our work is written to be ready for that third-party clearance testing.
Do you bill my insurance company?
Yes. For covered claims we document the loss, work with your adjuster and bill your carrier directly. Take pictures and write down when the leak or odor began. That record helps the adjuster understand the loss.
Will the mold come back?
Mold is a moisture problem before it is a cleaning problem. If the pipe, drain, flashing or condensation issue is not repaired, growth can return. After the source is stopped the structure still has to be dried, and we use moisture readings to confirm it.
Areas We Serve
From our shop at 2418 Basse Rd in San Antonio, we also serve:
Need help today?
We answer 24/7/365 and dispatch from San Antonio.
Financing available — click here to apply · Ask about our Whole-House Allergy Treatment
